en:rdc:devices:rm_4pi_installation []

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
<WRAP box>

==== Jooby Devices  ====
  * [[en:rdc:rmu_modules|Radio modules universal/multichannel (RM)]]
  * [[en:rdc:sensors|Sensors and Cables]]
</WRAP>


<WRAP box>
==== Jooby Development  ====
  * [[https://github.com/jooby-dev/jooby-docs|Message documentation]]
  * [[https://github.com/jooby-dev/jooby-codec|Message encoders/decoders]]
  * [[https://jooby-dev.github.io/jooby-gui/|Message encoders/decoders GUI (Demo)]]
  * [[https://github.com/jooby-dev|API for interacting with Jobby devices. Other documentation]]
</WRAP>


----

<WRAP left box>
  * [[en:rdc:gas_accounting:RM_module_work_description|Description of work. Commands. Parameters]]
  * [[https://github.com/jooby-dev/jooby-docs/blob/main/docs/analog/commands/readme.md|Command and Parameter Examples]]
</WRAP>

===== RM 4PU/4PI Radio Module - Installation/Activation =====

  * Connect the Sensor cable connector to [[en:rdc:sensors|Jooby Splitter 1x4PU/1x2PU]] and fix with nuts (Fig.1-2-3). 

{{:en:rdc:devices:1.jpg?direct&300|Fig.1}} {{:en:rdc:devices:2.jpg?direct&205|Fig.2}} {{:en:rdc:devices:3.jpg?direct&305|Fig.3}} {{:en:rdc:devices:6.jpg?direct&285|}} 

<WRAP left important>
Attention! On the Jooby Splitter 1x4PU/1x2PU cable there are **clips** indicating the port number of the Radio Module (Fig.5).
</WRAP>

<WRAP clear/>


{{:en:rdc:devices:4.jpg?direct&300|}} 

  * **Activation**. Connect the connector of the 4-port cable to the Radio Module and fix it with the nut (Fig.5). When the connector is connected to the Radio Module, an **Activation** event is generated. To reactivate module, disconnect and connect again the 4-port cable connector to the Radio Module. 
{{:en:rdc:devices:6.jpg?direct&300|}}

  * **Optional!** Forced sending of the current values of the pulse counter on all ports. Bring the magnet for a few seconds to the body of the Radio Module in the designated area (Fig.6).
{{:en:rdc:devices:7.jpg?direct&300|}} 

After the magnet is applied, the Radio Module will send the current value of the pulse counter to all ports.